What is the trick in modifying the plastic surface in terms of reshaping? I recently purchased a portable washer for an 07 Dutchmen tundra (fifth wheel), and I calculated the best area to place it is in the tub, however the corner of the shower has a shampoo holder shaped outwards and is part of the whole single waterproof plastic piece surface that surrounds the shower and is preventing my washer to sit flush against the corner.
I'm debating on cutting the corner out, which would leave me to have a gap that will need sealing from water, is there plastics I can buy or anything I can mold within the gap? What's the best option to go about this?
Cheers!
I'm debating on cutting the corner out, which would leave me to have a gap that will need sealing from water, is there plastics I can buy or anything I can mold within the gap? What's the best option to go about this?
Cheers!