EPDM Coatings
rvupgradestore.com Composet Products Custom Yacht Interiors

Author Topic: Wiring Question  (Read 739 times)

Flats Dude

  • Posts: 1
Wiring Question
« on: November 07, 2016, 03:40:45 PM »
Just signed on! We just purchased a gently used 2009 Fleetwood Coleman Westlake pop up. While figuring out the ins and outs recently, we were draining the freshwater tank and noticed the wiring on the curbside underneath has been installed between the flooring and the frame. There are quite a few wires that appear to be factory installed.
My question is this...Wouldn't this cause wear to the insulation causing a short and possible fire as time goes on? Pr is that just how they do it? Thanks in advance!

Gary RV_Wizard

  • Forum Staff
  • ---
  • *
  • Posts: 61019
  • RVer Emeritus
Re: Wiring Question
« Reply #1 on: November 08, 2016, 11:02:43 AM »
Hard to say without seeing it, but wear generally requires either movement or continuous pressure. Do either of those things apply there?  RV makers have been known to do some really dumb things, sometimes by design and sometimes just cause an asesmbly worker got lazy or in a hurry.

What sort of wires? 12v stuff or the 120v shore power hook-up?  12v is a lot less dangerous even if it does short out. Not zero danger, but less than 120v.
Gary
--------------
Gary Brinck
Summers: Black Mountain, NC
Home: Ocala National Forest, FL

robertusa123

  • ---
  • Posts: 1507
Re: Wiring Question
« Reply #2 on: December 13, 2016, 05:31:27 PM »
Totally normal in a camper.   I would guess that's the 12volt wireing for the brakes and brakes light. 
1996  26ft. 3 kids 2 dog and the wife too

 

Hosted by Over The Network