EPDM Coatings
rvupgradestore.com Composet Products PO Box Zone
Over The Network Custom Yacht Interiors

Author Topic: Slide motor install Power gear  (Read 385 times)

2011winnie

  • ---
  • Posts: 45
Slide motor install Power gear
« on: January 12, 2017, 08:37:26 AM »
From my other slide issue posting:

Are there any particular things I need to know about installing a new Power Gear slide motor? It looks like there are 4 bolts and that's it. Do I need to do anything with the brake on the motor?  Part # is 1010002069

New motor is around $700, just wanted to save on labor charges if it is an easy DIY.

2011 Winnebago Access Premier 31JP front drivers side slide, rear motor.

Thanks!!
2011 Winnebago Access Premier 31jp

Old_Crow

  • ---
  • Posts: 372
  • Home is where you make it.
Re: Slide motor install Power gear
« Reply #1 on: January 12, 2017, 05:41:39 PM »
Don't know anything about it, but I just found the motor for my slide yesterday(new-to-me coach)and I'm not sure I could get in there to crank the slide in if it fails, like they say you can in the manual. 
Over the top of the leveler jack reservoir/pump assembly behind a panel on the back wall of the house battery compartment.  What were they thinking?
Wally Crow
Retired 30 year ASE Master Auto Tech
Y2K Bounder 36S F53
'03 Jeep Wrangler Sahara

2011winnie

  • ---
  • Posts: 45
Re: Slide motor install Power gear
« Reply #2 on: January 12, 2017, 09:09:29 PM »
I figure that if I'm forking out $700 for the motor I might as well just have them install it.  Murphy often follows me around....lol
2011 Winnebago Access Premier 31jp

 

Hosted by Over The Network