EPDM Coatings
rvupgradestore.com Composet Products PO Box Zone
Over The Network Custom Yacht Interiors

Author Topic: FILON question  (Read 202 times)

scothern99

  • ---
  • Posts: 13
FILON question
« on: July 17, 2017, 01:17:14 PM »
Is it possible to cut Filon?  I need to get to the outside sheeting on my Class A and I cannot afford to buy new Filon.  Mine is still intact and not really messed up.  Delaminated yes, damaged, no.  Can I make a small cut on the side and remove, clean and reuse a section of my FILON siding?  Has anyone tried this before?  I have a 10 foot section of wall I need to remove/replace due to a hidden water leak that I discovered the hard way....

John Hilley

  • ---
  • Posts: 1643
Re: FILON question
« Reply #1 on: July 17, 2017, 02:17:48 PM »
Yes, you can cut it. Try to cut along an edge so that it doesn't show when glued back in place. You must use pressure to glue it back. It is best to use a piece of plywood against the Filon and brace it against something to keep the pressure applied.
2003 Winnebago Adventurer 38G
1999 Jeep Cherokee Sport
1999 Winnebago Brave 35C
  Handicap Lift & Hospital Bed

Rene T

  • ---
  • Posts: 9838
  • Great being on the right side of the grass
Re: FILON question
« Reply #2 on: July 17, 2017, 02:24:52 PM »
How big of a piece are we talking about?
Rene & Lucille & co-pilot Buddy
AKA  Pep N Mem
2011 Chevy Duramax 2500 HD 4X4
2011 Montana High Country 343RL
From the Granite State of NH
& Florida Snowbird in Lakeland FL

scothern99

  • ---
  • Posts: 13
Re: FILON question
« Reply #3 on: July 17, 2017, 04:56:15 PM »
Basically a third of my wall. I can cut above the door and then I will have just a short seem. The rest of it is mostly a big window cut out. So about a 9x10 section if I had to guess.

 

Hosted by Over The Network