Sponsored by Winnebago Industries

Author Topic: Trim installation for slides on Win 34y circa 2011  (Read 121 times)

Ernie n Tara

  • ---
  • Posts: 3274
  • Life is Good - Together
Trim installation for slides on Win 34y circa 2011
« on: September 07, 2017, 04:00:49 PM »
My control for the full body slide screwed up today; actually reversed the operation of the slide. I can handle the electrical aspects, but I can't tell how the trim is attached (I actually pulled some free running the slide with the IN buttom and the slide trying to go out). The wood trim plate (looks like a rack gear) is attached to another plate that is in turn screwed to the edge of the slide box; I can see the screws when I pull the trim out. I suspect the wood plate is glued to a metal plate that the screws go through. Does anyone know for sure? Best way to remove so I can replace the screws. Or is it just better to simply reinforce with screws through both pieces (the problem is at the back edge on the bottom in the bedroom and shouldn't show). Opinions, info, or solutions.

Ernie

FYI When this happened, I first got a flashing FAULT light and the slide wouldn't move. I pulled the panel and reset with the switch on the back. The light went out and then the buttons worked, but backwards. I didn't notice until I had pulled the trim loose. Lots of power there. 
« Last Edit: September 07, 2017, 04:06:38 PM by Ernie n Tara »
Ernie 'n Tara

2011 Winn Journey 34y
2012 Jeep Rubicon - Dozer (orange - kinda)
2006 Jeep Wrangler

ChasA

  • ---
  • Posts: 246
Re: Trim installation for slides on Win 34y circa 2011
« Reply #1 on: September 08, 2017, 09:51:43 AM »
Erie, whenever my slide out error lights flash, I have been successful in resetting  the problem by turning the chassis battery off at the switch by the door. I know this doesn't answer your question. But maybe it will be useful in the future.  Sorry I can't help with the trim problem.
Apex, NC
2010 Winnebago journey Express 34Y (pre DEF)
2007 Saturn Vue

 

Hosted by Over The Network