Hello All:
We finally made an RV purchase. The only trip thus far has been to install the tow and brake system. Otherwise it has been in storage while I continue to purchase needed items, familiarize myself with the motorhome systems and work clearing our house hoping to get it on the market in 30 days. Yes we are jumping into full time whole hog. Very excited...very nervous.
I'm trying to address a problem with inflating my rear tires. I purchased a portable compressor but my inner rear dual valve stem is in a very difficult position to inflate and/or monitor. I verified the stems are metal. After looking at options and other postings I was planning on using a wheel master 45 Degree extender and then a 4 inch straight extender that would poke through the outer ring hole and then stabilize it with a rubber plug made by Always Shine wheels in the outer rim hole. After reading postings I'm concerned about adding two additional leak points. Is this a sound plan or am I asking for trouble. Any better options anyone can suggest. I attached a jpg of the parts but I'm not sure the jpg will appear (rookie at this as well!)
Thanks
Dave
We finally made an RV purchase. The only trip thus far has been to install the tow and brake system. Otherwise it has been in storage while I continue to purchase needed items, familiarize myself with the motorhome systems and work clearing our house hoping to get it on the market in 30 days. Yes we are jumping into full time whole hog. Very excited...very nervous.
I'm trying to address a problem with inflating my rear tires. I purchased a portable compressor but my inner rear dual valve stem is in a very difficult position to inflate and/or monitor. I verified the stems are metal. After looking at options and other postings I was planning on using a wheel master 45 Degree extender and then a 4 inch straight extender that would poke through the outer ring hole and then stabilize it with a rubber plug made by Always Shine wheels in the outer rim hole. After reading postings I'm concerned about adding two additional leak points. Is this a sound plan or am I asking for trouble. Any better options anyone can suggest. I attached a jpg of the parts but I'm not sure the jpg will appear (rookie at this as well!)
Thanks
Dave