AStravelers
Well-known member
I have a 2006 Winnebago Sightseeer, 29R Class A motorhome. Over the last 4 months, on both the driver side and the passenger side windows, the glass pane has come loose from the rubber gasket holding it in the frame. The drivers side has come so loose you can slide the glass up, down, left and right about 3/8? to 1/2?. So far the passenger side has only slipped down a little. Duct tape is holding the glass in place.
There will be pictures towards the bottom of this posting, but first my questions:
? Can I just buy a new rubber gasket and slip it in place around the glass?
? Or will I have to remove the whole window frame, separate the inside and outside frames to replace the gasket?
? Where can I get a new gasket?
? Any other suggestions about what to do?
(No, I am not going to take caulking and squeeze it into the frame to hold the glass in place.)
The images below are:
-- Drivers side window
-- Passenger side window
-- The gasket pulling away from the glass in the lower corner
-- End view of the gasket. The left side is the outside edge of the gasket.
-- Side view of the outside edge of the gasket.
There will be pictures towards the bottom of this posting, but first my questions:
? Can I just buy a new rubber gasket and slip it in place around the glass?
? Or will I have to remove the whole window frame, separate the inside and outside frames to replace the gasket?
? Where can I get a new gasket?
? Any other suggestions about what to do?
(No, I am not going to take caulking and squeeze it into the frame to hold the glass in place.)
The images below are:
-- Drivers side window
-- Passenger side window
-- The gasket pulling away from the glass in the lower corner
-- End view of the gasket. The left side is the outside edge of the gasket.
-- Side view of the outside edge of the gasket.