The inside lights on 2015 Winn Vista have only 2 wall switches that control 2 lights. All the test of the ceiling lights are turned on at each light with a button on the light. My question is does anyone have an "easy" way to connect some of these lights to a wall mounted light switch? How hard is it to run wire from a ceiling light to a new wall switch?
Winnebago 2015 Vista, inside lights
- Thread starter slowrider
- Start date
The friendliest place on the web for anyone with an RV or an interest in RVing!
If you have answers, please help by responding to the unanswered posts.
If you have answers, please help by responding to the unanswered posts.
AStravelers
Well-known member
Very, very hard to run the wire inside the ceiling and walls.
In my 2012 Vista same problem. Solved for me by replacing awkward button on fixture with a pull cord operated switch, easy fix, a lot more convenient, especially the one over the dining tale which was a PIA, only one side of the seating could reach the button. Cords, not chains, which are too noisy under motion.
By the way, it was a sloppy install from the factory, screws just barely in some wood, likely would've come own on it's own eventually.
By the way, it was a sloppy install from the factory, screws just barely in some wood, likely would've come own on it's own eventually.
