Sponsored by Winnebago Industries

Author Topic: 2000 adventurer 35u. Waste valve replace  (Read 416 times)

Jiml100

  • Posts: 4
2000 adventurer 35u. Waste valve replace
« on: December 26, 2017, 04:44:30 PM »
Anyone know how to take the panel out with the outside shower and water hook ups, so I can get to the waste valves and cables, they are leaking when off, getting old I guess,

afchap

  • ---
  • Posts: 1204
    • The Empty Nest
Re: 2000 adventurer 35u. Waste valve replace
« Reply #1 on: December 26, 2017, 06:23:06 PM »
My panel is in three pieces ... one across below the water lines, one above the lines, and one that the lines go through. Removing the top and bottom strips isn't terribly bad. But removing the middle strip would require talking every connection loose ...mine are compression fittings which I believe have to be cut to take them apart. I doubt you want to go there. I have been able to tighten one or two that were leaking, and replaced the guts of one valve. Good luck. Go slowly, and take pictures before disassembly if necessary to remember how things go back in.
Paul ... (KE5LXU), was fulltimin', now parttimin'...
'03 Winnebago Ultimate Advantage 40e
'05 Honda Odyssey toad
Escapees, FMCA, SMART, WIT
http://www.pjrider.com

John Canfield

  • Forum Staff
  • ---
  • *
  • Posts: 12634
    • Jane and John's Internet Home
Re: 2000 adventurer 35u. Waste valve replace
« Reply #2 on: December 27, 2017, 07:12:21 AM »
Here's a write-up I did when I installed a Garnet tank monitor system. On one of the pages I show how I removed the metal fascia in the plumbing bay. It may or may not be applicable for your rig.
--John
2005 Horizon 40AD, 2006 Jeep Rubicon Unlimited
Our Horizon projects
Our weather