I'm at a loss on figuring this one out. Can't wrap my head around it or any diagrams I Googled.
My city water hooks up to a point on my MH. There is a valve there to fill the fresh water tank from the same connection. It is off, but my fresh water tank keeps getting filled. (At a slow rate) The shutoff valve is working and not leaking.
At the suggestion of Rene, I thought i would check the check valve at the pump.
I shut off the city water. I took one line off of the water pump. When I turned the city water back on, no water came out of that line until I turned the tank fill valve on.
I hooked that back up to the pump. I turned the tank fill valve off. I took the line off from the other side of the pump. When I turned the city water back on, water came forcefully out of that line.
Which is which and goes to the fresh water tank? My thought was to just cap whichever end leads to the tank, as I never use it. I'm sure it's simple, but I just can't wrap my head around it.
My city water hooks up to a point on my MH. There is a valve there to fill the fresh water tank from the same connection. It is off, but my fresh water tank keeps getting filled. (At a slow rate) The shutoff valve is working and not leaking.
At the suggestion of Rene, I thought i would check the check valve at the pump.
I shut off the city water. I took one line off of the water pump. When I turned the city water back on, no water came out of that line until I turned the tank fill valve on.
I hooked that back up to the pump. I turned the tank fill valve off. I took the line off from the other side of the pump. When I turned the city water back on, water came forcefully out of that line.
Which is which and goes to the fresh water tank? My thought was to just cap whichever end leads to the tank, as I never use it. I'm sure it's simple, but I just can't wrap my head around it.