Senatordan39
New member
- Joined
- Oct 16, 2018
- Posts
- 1
Recently, I took my RV up to the mountains where it was getting fairly cold. I set my dual-zone thermostat for both furnaces to approximately 65?. When I came back to the RV the RV was well into the forties inside the coach. In order for the furnaces to both turn on I had a slide both temperature dials up to the 90-degree mark. Once they were on, I would slide the dials both back down to about 65. The coach interior temperature got well into the 80s but never turned off. the only way to turn off the furnaces was to turn the dial to off and in order to turn them back on I had to slide the dials both to 90 with the switch back on heat. A couple times the rear would turn off, but the front never would based on temp. I have the 00-00591-100 Intellitec Power Management System Control Module. Any thoughts on what I should do it what part to replace. I haven't been successful in finding a different system with the power shed feature for two AC's/furnaces. TIA
