hello.
been searching the site and found LOTS of furnace related info.
no hint of my problem. so here goes.
had a motor squeal in suburban sf 25f . all worked fine. good heat, proper thermostat control.
all great. just a bit loud.
removed unit and * unplugged*
dissembled to replace bushing and found no parts for sale. oh well. welcome to R.V.
bought new motor and replaced and bench tested. all fine.
when attempting to reconnect the harness to the control module I have problem
(not sure how previous owner had it wedged in for all to work)
wire plug in has 6 holes with 3 filled with yellow brown red wires and other 3 empty.
board has 5 pins.
he had it jammed in and all worked.
I know am working with red 12 v+ yellow 12 v- and brown to valve.
which positions will those 3 wires go on the 5 pin board?
thanks in advance,
gary
been searching the site and found LOTS of furnace related info.
no hint of my problem. so here goes.
had a motor squeal in suburban sf 25f . all worked fine. good heat, proper thermostat control.
all great. just a bit loud.
removed unit and * unplugged*
dissembled to replace bushing and found no parts for sale. oh well. welcome to R.V.
bought new motor and replaced and bench tested. all fine.
when attempting to reconnect the harness to the control module I have problem
(not sure how previous owner had it wedged in for all to work)
wire plug in has 6 holes with 3 filled with yellow brown red wires and other 3 empty.
board has 5 pins.
he had it jammed in and all worked.
I know am working with red 12 v+ yellow 12 v- and brown to valve.
which positions will those 3 wires go on the 5 pin board?
thanks in advance,
gary
