Hi All,
I am trying to trace down a problem with my P2 which has been working ok for the past 5 years. The controller displays at times PL which means power loss during braking. I have replaced the trailer power tail (long over due to a pullout earlier) and looked at all the wiring on the trailer and cannot see anything bad there. The truck connector also looks good. Here are some key points:
- The brakes work when the manual lever is applied.
- The PL error does show up if the manual lever is slid to harshly.
- The brakes work when the breakaway switch is activated.
- The brakes are in adjustment.
- The brakes also work when manually rotating the tire in the air and applying the brake pedal.
Does all of this seem to point to the controller? If so , how should I check that?
I am trying to trace down a problem with my P2 which has been working ok for the past 5 years. The controller displays at times PL which means power loss during braking. I have replaced the trailer power tail (long over due to a pullout earlier) and looked at all the wiring on the trailer and cannot see anything bad there. The truck connector also looks good. Here are some key points:
- The brakes work when the manual lever is applied.
- The PL error does show up if the manual lever is slid to harshly.
- The brakes work when the breakaway switch is activated.
- The brakes are in adjustment.
- The brakes also work when manually rotating the tire in the air and applying the brake pedal.
Does all of this seem to point to the controller? If so , how should I check that?