2000 adventure headlight bezel locks
- Thread starter Kernsm74
- Start date
The friendliest place on the web for anyone with an RV or an interest in RVing!
If you have answers, please help by responding to the unanswered posts.
If you have answers, please help by responding to the unanswered posts.
darsben
Well-known member
Cann it be glued? If so my first choice would be JB Weld otherwise the appropriate GORILLA glue would be my solutions
John Canfield
Site Team
CA adhesive might work ("super glue.")
X
X-Roughneck
Guest
Kernsm74 said:
I would get some 180 grit and fold it. Sand scratch up the original Surface mounting area only, or scratch it with a utility knife to get it nicked up so the glue will bite into fresh clean then probably I would try Gorilla Glue carefully on the original foot print and place a "X" of Blue tape to hole down pressure while holding the set up of glue.
When Gorrilla glue dries it has a eXpansion Foam look to it.
Expands when drying so a Temp fix it might work well if you tape it for the set up?
Get home and dremel ball it down and re-apply to the flat original surface as they did on factory installation.
JD
