EPDM Coatings
rvupgradestore.com Composet Products PO Box Zone
Over The Network Custom Yacht Interiors

Author Topic: HR Alumascape 2005 30FKS  (Read 2414 times)

WilH

  • Posts: 3
HR Alumascape 2005 30FKS
« on: June 14, 2005, 08:41:20 PM »
Does anyone here own the above TT?  We just bought one and we love it.  However, under the slideout there are three bars.  The center bar is not bolted to the slideout at the outside edge but has a screw (and washers) that is not tight.  In fact there is about 1 1/2 inches of movement of this bar in and out over this screw.  Is this normal?  Should this screw be tight?

Also, the left side of the slideout (looking at it from inside the trailer from the kitchen entry door) is creating a mark on the carpet and actually damaging the carpet that is attached to the TT's floor.  Is there a way to adjust this so that the edge of the slide out does not drag on the carpet?

Thanks in advance,
Wil H


Ron

  • Former Staff
  • ---
  • Posts: 18087
Re: HR Alumascape 2005 30FKS
« Reply #1 on: June 14, 2005, 08:51:20 PM »
With a rig that new I would recommend you take it to the dealer to get it fixed and request they inspect it for other defects in workmanship while they are at it.
Ron & Sam-home is where we park it. Currently located   HERE

WilH

  • Posts: 3
Re: HR Alumascape 2005 30FKS
« Reply #2 on: June 14, 2005, 08:57:24 PM »
Thanks Ron.  That is what we will probably do this weekend.  I was hoping that it would be an easy fix that I could do here.
Wil

Ron

  • Former Staff
  • ---
  • Posts: 18087
Re: HR Alumascape 2005 30FKS
« Reply #3 on: June 14, 2005, 09:02:45 PM »
Thanks Ron.  That is what we will probably do this weekend.  I was hoping that it would be an easy fix that I could do here.
Wil

It might be an easy fix but it is best to take it to the dealer so these things are properly documented in case of future problems.
Ron & Sam-home is where we park it. Currently located   HERE

 

Hosted by Over The Network