zzrver
Member
I have a 9000 awning where the RH end cap is loose and wobbles a bit. This causes the cam lever to not sit perpendicular and does not function properly. I have to work at it to get the lever to move when in the stored position. When unfolded, it is at eye level so I can move the end cap with my hand and not too much problem getting the lever to move. Is there anything that might be fixable inside if I take the assembly off? Or do I just need to get a new torsion assembly? I will have to drill out the pop rivets in either case to get it out. Any comments or advice?
Thanks,
John
Thanks,
John