EPDM Coatings
rvupgradestore.com Composet Products Custom Yacht Interiors

Author Topic: coleman aluminum roof  (Read 1080 times)

DD1229

  • Posts: 3
coleman aluminum roof
« on: June 11, 2013, 06:57:11 PM »
Hello all. Apparently some water got under one of the tracks on the roof ( 04 coleman Bayside ) and now I have a small amount of wrinkles on the ceiling covering. I have removed cleaned and sealed (Dicor) now is there a way to remove enough of the "headliner" to remove the wrinkles, and then glue it back without destroying it. the ceiling still feels solid so I hope this doesn't become too involved. any suggestions or insight would be appreciated.
Thanks, DD

tnguy

  • ---
  • Posts: 144
Re: coleman aluminum roof
« Reply #1 on: June 16, 2013, 01:47:18 PM »
this is free advice so take it as that... :)

i have used a razor blade and made tiny slits in the wrinkles and then used a NON staining glue and some painters tape to hold it in place till the glue dried, when it was done you almost had to know it was bad before because you couldnt hardly see it...

 

Hosted by Over The Network