EPDM Coatings
rvupgradestore.com Composet Products Custom Yacht Interiors

Author Topic: Anyone with a 2013 Jeep Rubicon with AirForceOne/SMI Braking System?  (Read 795 times)

4ducksrus

  • ---
  • Posts: 814
Is there anyone out there that has a 4 door Jeep Wrangler/Rubicon that is using the AirForceOne Braking System?  If so, where under the hood did you mount the control box?  My DH can't seem to find room anywhere!  We had it on our older Jeep Sahara and there was plenty of room, but this jeep has a very crowded engine compartment!!
TIA
Mikie
Jim & Mikie

2011 Itasca Meridian 40U
2013 Jeep Rubicon
2003 HD Ultra Classic
WIT WI54011

Barb

  • ---
  • Posts: 1108
Barb
2003 NRV Tradewinds LTC
2011 Jeep Rubicon Unlimited

Mavarick

  • ---
  • Posts: 2030
Re: Anyone with a 2013 Jeep Rubicon with AirForceOne/SMI Braking System?
« Reply #2 on: June 07, 2014, 10:45:03 PM »
This is not a jeep but I post it to give you the idea, sometimes you have to get creative. You can mount the AFO above the engine or where ever you would like it. With a 3' x 1/2" piece of steel flatbar from home depot cut into 2 lengths. Drill it and use wire ties to mount so it is easy to move later if needed. Here I have the AFO unit mounted and a charging regulator towards the back. Hope it helps.
2009 Tiffin Allegro Bus 43 QRP
Powerglide Chassis, 425 Cummins, Allison 6 Speed
2010 CRV - Blackhawk 2 - Air Force One
2002 Heritage Classic
Washington State

Ernie n Tara

  • ---
  • Posts: 3294
  • Life is Good - Together
Re: Anyone with a 2013 Jeep Rubicon with AirForceOne/SMI Braking System?
« Reply #3 on: June 08, 2014, 10:12:20 AM »
In response to your email. I use an RVI in cab braking system so no box to mount. I just ran the breakaway switch wiring through one of the provided grommets in the firewall.

Ernie
Ernie 'n Tara

2011 Winn Journey 34y
2012 Jeep Rubicon - Dozer (orange - kinda)
2006 Jeep Wrangler

 

Hosted by Over The Network