EPDM Coatings
rvupgradestore.com Composet Products PO Box Zone
Over The Network Custom Yacht Interiors

Author Topic: moving floor heaters/blowers  (Read 1785 times)

cdat

  • ---
  • Posts: 95
moving floor heaters/blowers
« on: June 21, 2014, 06:57:24 PM »
I have a 91 Newel bus with above floor ducts for heating under the couch and the dinette. How difficult is it normally to try to relocate that type of heating in order to remove the couch and dinette?  Realize every bus is different but would I be better off converting to electric individual heaters or can these be converted to floor type ducts?

thanks
John
John and Patti
US Army (Ret)
91 Newel Bus #255
Lifetime Member DAV
Lifetime Member VFW

Ernie Ekberg

  • ---
  • Posts: 1479
Re: moving floor heaters/blowers
« Reply #1 on: October 05, 2014, 04:46:10 PM »
John, are those for your recirculating engine coolant?
Ernie Ekberg, Weatherford, Tx
Prevost Liberty Classic XL
www.ernieekbergflooring.net

Gary RV_Wizard

  • Forum Staff
  • ---
  • *
  • Posts: 60391
  • RVer Emeritus
Re: moving floor heaters/blowers
« Reply #2 on: October 06, 2014, 09:28:06 AM »
What type of heating? Ducted hot air from a furnace, or aquahot/hydrohot (hot water heating)?  I would suspect the latter in a Newell, and that typically means re-routing the heated water lines. The outlets are actually heat exchangers, blowing local air over a hot surface to provide heating. Maybe not all that difficult if you can get at them and do the plumbing needed to reroute lines.
Gary
--------------
Gary Brinck
Summers: Black Mountain, NC
Home: Ocala National Forest, FL

Ernie Ekberg

  • ---
  • Posts: 1479
Re: moving floor heaters/blowers
« Reply #3 on: October 06, 2014, 05:21:42 PM »
if they are plumbed with pex- even easier.
Ernie Ekberg, Weatherford, Tx
Prevost Liberty Classic XL
www.ernieekbergflooring.net

idtravelinman

  • Posts: 2
Re: moving floor heaters/blowers
« Reply #4 on: October 07, 2014, 11:16:07 AM »
i have a 1964 MCI-5. Conversion completed (can that ever be)  it appears that the original underfloor radiator is still in place and assume operable.
 is it possible or feasible to install a wabasto or the like directly into that system without a major undertaking??

idtravelinman

  • Posts: 2
Re: moving floor heaters/blowers
« Reply #5 on: October 07, 2014, 11:20:05 AM »
if anyone knows a MCI expert that would know about the original factory heating system and how it works i would appreciate a name and number.
 1964 MCI-5   GM 6-92
 thanks

 

Hosted by Over The Network