Suburban wall heater problem

cic317 · Nov 22, 2015

Hi everyone,
new to the boards & TC, just bought a used 2011 Adventurer 80, all checked out ok when we did the walk thru, today doing some odds & ends, winterizing & fired up the wall furnace. ran fine, but after shutting thermostat down, the fan will not shut off. I thought it was just a cool down mode, but 2 hours later still going. Ended up pulling fuse.I have gone thru the manual but it's no help. Hoping someone might have had the same issue.
the unit is a Suburban NT-16SE
thanks in advance !

kdbgoat · Nov 22, 2015

Is the fan switch in the "on" position or "auto"?

cic317 · Nov 23, 2015

I haven't found a switch, either on thermostat or heater. Did I miss it?

BruceinFL · Nov 23, 2015

Select Fan on the thermostat and then select Auto.

cic317 · Nov 25, 2015

The T-stat is heat only, No A/C, No fan switch. I haven't found any other switches,

BruceinFL · Nov 25, 2015

cic317 said:
The T-stat is heat only, No A/C, No fan switch. I haven't found any other switches,

Sorry, can;t help you there. Perhaps Gary or someone else will chime in.

Suburban wall heater problem

cic317

Well-known member

kdbgoat

Well-known member

cic317

Well-known member

BruceinFL

Well-known member

cic317

Well-known member

BruceinFL

Well-known member

Latest posts

Members online

Forum statistics