I just bought a new Forest River A-Frame and it has a Suburban SW6D Water Heater.
It is producing hot water - but not much. When I turn the switch on the reset light comes on for about a minute (or less) then I can hear the flame is on. After a half hour or so I can turn on the hot water faucet and get a few seconds of pretty hot water then only warm water, with an occasional 2 to3 second burst of hot water. The resulting sink full of water is slightly warm.
Is this what I should expect or should I be looking for a problem?
Thanks,
It is producing hot water - but not much. When I turn the switch on the reset light comes on for about a minute (or less) then I can hear the flame is on. After a half hour or so I can turn on the hot water faucet and get a few seconds of pretty hot water then only warm water, with an occasional 2 to3 second burst of hot water. The resulting sink full of water is slightly warm.
Is this what I should expect or should I be looking for a problem?
Thanks,