EPDM Coatings
rvupgradestore.com Composet Products Custom Yacht Interiors

Author Topic: Intellitec Climate control problems  (Read 659 times)

Dave w.

  • Posts: 2
Intellitec Climate control problems
« on: September 08, 2016, 08:42:18 PM »
 Have Intellitec  and have no heat or ac's but green lights come on and shedlights comes on too. No power to ac's or heat ?? and I have 120v power to ac boxes please help?

Dave w.

  • Posts: 2
Re: Intellitec Climate control problems
« Reply #1 on: September 08, 2016, 08:46:07 PM »
Also did test for front and rear ac's and they didn't come on

Just Lou

  • ---
  • Posts: 8125
Re: Intellitec Climate control problems
« Reply #2 on: September 08, 2016, 10:54:13 PM »
It sounds like you've lost the 12V supply to the controller, or the controller is defective.
'97 Bounder 34V (F53 w/tag), '99 Honda Accord EX

Gary RV_Wizard

  • Forum Staff
  • ---
  • *
  • Posts: 61008
  • RVer Emeritus
Re: Intellitec Climate control problems
« Reply #3 on: September 09, 2016, 12:03:00 PM »
I'm not clear about "shedlights comes on too." Are you saying some appliance power is being shed? Which ones?

My Intellitec display has green lights for "power on" and no light (dark) when in "shed" (no power) state. Does yours have a light that indicates the
"shed" state?

In any case, my first action woud be to reset the Intellite controller by removing 12vdc power to it. Usually this can be done via the battery disconnect switch if you have one of those. If not, disconnect the house battery ground cable for a few seconds, or remove the 12v power wire from the EMS controller (which will be part of the Smart EMS load center). This will rest and re-boot the Smart EMS controller and make fix your problem.
Gary
--------------
Gary Brinck
Summers: Black Mountain, NC
Home: Ocala National Forest, FL

Just Lou

  • ---
  • Posts: 8125
Re: Intellitec Climate control problems
« Reply #4 on: September 09, 2016, 01:49:04 PM »
I'm not clear about "shedlights comes on too." Are you saying some appliance power is being shed? Which ones?

My Intellitec display has green lights for "power on" and no light (dark) when in "shed" (no power) state. Does yours have a light that indicates the "shed" state?

In any case, my first action woud be to reset the Intellite controller by removing 12vdc power to it. Usually this can be done via the battery disconnect switch if you have one of those. If not, disconnect the house battery ground cable for a few seconds, or remove the 12v power wire from the EMS controller (which will be part of the Smart EMS load center). This will rest and re-boot the Smart EMS controller and make fix your problem.
Me thinks you are confusing the OP's Intellitec ECC (Electronic Climate Control) system with the Intellitec EMS (Energy Management System).  Big difference....
'97 Bounder 34V (F53 w/tag), '99 Honda Accord EX

Gary RV_Wizard

  • Forum Staff
  • ---
  • *
  • Posts: 61008
  • RVer Emeritus
Re: Intellitec Climate control problems
« Reply #5 on: September 10, 2016, 12:58:41 PM »
Ah, right Lou! I missed that in the topic title.

Ignore my previous remark.
Gary
--------------
Gary Brinck
Summers: Black Mountain, NC
Home: Ocala National Forest, FL

 

Hosted by Over The Network