RVing message boards > Tech Talk

Norcold 61x control board

(1/1)

Rono317:
I'm new to RV"s, I'm a electrician , I'm trying to figure out where to access the power board  for my Ref.
I've downloaded the service manual and I see where it says my fault code 4 flashes every 3 seconds "board failure
Replace power board"
Any help would be appreciated , I not sure where to start
Thanks

John From Detroit:
On most fridges there is a panel on the OUTSIDE of the RV that you can remove usually with just a coin to turn the quarter turn locks (Some need a screwdriver) you may even be able to turn them with just your fingers.
The board (S) are back there.   On my Dometic there are two boards, one you see right away, the other is in a black box on the left,  I do not know exactly where Norcold puts them.

If you need to replace.. Consider Dinosaur boards, if they make one for your unit (They do not cover them all) Well... I got a Dino board for my furnace.

Very well built,  Has protection to prevent what I think happened, and less than half the cost of an OEM.. All in all, I'm very happy with this new board.

Rono317:
Thanks  John , I know the question seemed pretty novice but I sure want to thank you for the reply
Ron

Navigation

[0] Message Index