Recent content by 2011winnie

Just an update, it was a dumb thing on my part. I apparently did not turn the fill valve back to the right position....all is good  Duh

Thank you for the replies. No obvious leaks, took as many covers off as I could to see inlet/outlet hoses. Valves are in right direction. Took filter off and all seems very clean. Did not check voltage at pump yet.

Had the RV out this past week. Filled up the on board tank rather than use the camp sites bad water. Could not get normal pressure, just an annoying trickle and the pump would not shut off. Also notice that the toilet water would not shut off which may have been the cause of the pump not...

UPDATE    The Jensen TV seems to be the problem. I tried another TV and it worked great!  I went to install the new TV, but I found out there are not the same amount of plug ins in the new TV as the Jensen has. Another minor setback/headache. I bought a splitter that will work for the new TV. ...

On my 2011 Access Premier 31JP the "Box o buttons" pulls out from the front. It was hard to see in your picture if there is a face plate on yours or not. If there is, this is how I get to mine.  As far as the TV, mine is mounted on a swivel bracket, sorry.

What they said,  have engine running and make sure batteries are good.

UPDATE  The shop that diagnosed the problem as a motor wanted $900 for a new motor plus 1-1/2hrs labor. I had been to the Pittsburgh RV show and saw that Butler RV Sales in Butler, PA was a new Winnebago dealer. I was able to order the motor from them for $700 and decided just to have them...

Yup, see my post

Yea, If this was an 8 trac in a 1974 Chevy I'd be all over it...lol I think the TV should work too. It was set to "air" when I checked it out. It does work with the DVD, I haven't had it connected to cable yet. I'll check and see it there is some sort of "reset" for it. The TV is a Jensen...

Finally had the time to work on this. I used a second TV to rule out some things. I traded off coaxial connections from the BOMB to this TV. Everything worked using the second TV, I was able to get as many as 22 channels. I then hooked up the factory installed TV again and it still wouldn't pick...

I figure that if I'm forking out $700 for the motor I might as well just have them install it.  Murphy often follows me around....lol

I found it.  The right one is around $700. Part # 1010002069 I posted in the Tech Section asking about a do it yourself install. Looks like 4 bolts and that's it. Not sure about the motor brake or what to do if anything with it. Just trying to save some costs on labor. Any idea's on...

From my other slide issue posting: Are there any particular things I need to know about installing a new Power Gear slide motor? It looks like there are 4 bolts and that's it. Do I need to do anything with the brake on the motor?  Part # is 1010002069 New motor is around $700, just wanted to...

If its the right one, $350

UPDATE  RV service said rear motor was bad and needs replaced. Don't have any estimate as they haven't checked on part price yet. I thought that was unusual. Part # listed on service sheet is #1510000042 and comes up on ebay. Other numbers with no explanation are B01D06286 and S#10A0002...