Recent content by anshood

Well I started my trip and tranny acted up again and no cruise. I also had problems with chassis battery . To make a long story short I cleaned battery cleaned all post and cables, and after all that I started home and and tranny did perfect and cruise started working. Do you think the battery...

Well I'll check with a transmission man in my home town that is reliable and very reasonable. He's repaired several Chevys for me. My try the additive before I decide on rebuild or replace. Wish Allison made one like I had with no trouble with it In my Chevy 2500 that I pulled a 36' all over...

I have a 1999 Bounder 36S and  I am having the same problems on vacation in New Mexico now. I also agree that the battery terminals can be problem because that's what got mine going today after cleaning them.  Over a period of time the corrosion creeps up into the insulated part of the cables...

Well I changed the fluid, filter and TPS. Left home and problem started again about 1-1/2 hrs dos the road. Stopped at redlight and sluggish and weak and jerky motion. Dropped to lo gear and manually shifted did good in manual shift. Anyone have any more suggestions other than tranny  overhaul...

I plan changing fluid and start there. Thanks for the info.

I noticed my Ford F53  1999 Bounder motorhome transmision slow to get going and sort of stalling and when accelerating somewhat of a jerking motion .After shifting to 2nd gear does fine. Just slow jerking start. Any suggestions.

Purchased new controller today and before I installed it I traced some more wires after checking everything again. Did find another fuse behind plate in front of passenger seat. It was good and while in this place I found 2 wires that appeared rat chewed into. Like to have never found where they...

Cannot get a/c compressor on dash to come on. Checked every fuse on motorhome all good Bypassed pressure cut out switch Put 12 volts on compressor clutch,it kicks in Replaced main control on dash $$$$$ 100# pressure on low side with compressor not running and has gas in it. Can't check hi side...

You are absolutely correct, not finding replaceable detector. I installed a new gas/co alarm in old detectors place. I'll take your  advice and remove solenoid. I also replaced every detector and installed more. in motorhome . Feel confident enough now. Checked all gas line connections for...

Thanks for the web site . I see how wires are connected. I found other end of wires rats had chewed. Replaced and ordered a gas/co detector but got wrong thing.I temporarily put an on/off switch on one 12 v service and checked out oven, water Htr  and heat systems. All work but don't feel...

Converter

I have this situation with my gas detector wires. I have been remodeling my MH and was removing gas detector and when I pull alarm out of wall I notice a lot of slack in wires. I began to pull on wires and found rats had eaten them into. Can't get gas on now. I have removed everything to get...

You know I thought I had responded thanking each of you, so sorry. Several medical opportunities but back on the road. I was told to get some absorbent from Walmart in bags. I did and it worked. Keep theses handy now. Also bought s dehumidifier that works well during extremely damp conditions...

I am located in the east Texas area. We have had some really high humidity and rain in our area this year. Based on what Linda has described I think my problem was created by me running the vent fan and therefore sucking in all that moisture through a slightly cracked open window. My motorhome...

I found mold on my wooden window blinds. What usually causes this and how can I prevent it in the future. I have had my motorhome under shed all the time. I did have a vent fan on with the intent to keep circulated in motorhome. I do not remember having this problem before.