Recent content by bajasoon

Hello everyone...I hope you are all well and staying safe. While keeping busy cleaning and painting my rear engine compartment, I see that my diagnostic plug is missing.  It had been loose and I kept trying to tighten the screw that held a latch that attached to it. I think the last time the...

PS  system is 325 HWH jack / leveling system Thanks, Dawn

Hi and Happy New Year! I've been trying to get a picture / description of what this screwed in bolt / plug is on my HWH jack cylinder to no avail.  It's on the sleeve that the rod goes up into, near the bottom. It looks like it's just a 1/2" bolt, with a washer, into the unit. Is this where one...

Hi Steven I do have a Tric-L charger hooked up. I also have 10 amp solar panel, meager, but suppose to help keep coach batteries up.  But I am confused: Some say to turn OFF the Aux. Batt switch  (disconnect switch) while unit is stored for a few weeks to keep minor drain from occurring. But...

Thanks, Jeff.. That seems like more than I can do right now. Maybe when camped out in the Baja this winter..if I can afford the fuel now! :-) One more question I have is...if I run the on-board generator, will that charge the engine batteries or just the coach ? Do you know? Thanks, again, Dawn

Thank you John!  Yes, I think that's the best way to go.  Getting a clamp on there might be tricky, especially on the bottom.  Thing is, it is pulled away a bit with the hood open. To get it up tight to body the hood has to be held up some.  I'll need some extra hands! Thanks, again,  this forum...

For everyone  trying to help me with the hood on a Winnie,  here are some pix. If you look along the edge of bracket mechanism, you'll see what's left of the white epoxy that either the company used or last owner did. It is very soft and almost powdery now. And see the bolting system. They are...

Hi John, It is a process ...i have to download into computer from camera, shrink, then upload here. I have to leave for work now and can't do this until this afternoon!  I will get them on here later today. Thank you...and I hope you can check back later. Dawn

Hi Red T, I looked at this again (and took pictures, Kevin, but have to wait till tomorrow to use other computer to download)..and it seems all the bolts holding it on are rivets, not regular bolts. I don't have any tools to either undo those or put it back together far as I can tell.  Did yours...

Hi Kevin, Thanks for your response. I will try to get some pix  but not sure how much I can get on film. Awkward position in there!  May not be able to until tomorrow, but then I'll post what I can get. Thanks, again, Dawn

Howdy, I'm having the darndest time finding any info on removing the front hood (generator compartment) on 2004 winnie journey.  The brackets that the hinges are attached to are pulling away from the body. I read several other's have this problem, but no one has mentioned whether you can take...