You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
Recent content by Blues Driver
The friendliest place on the web for anyone with an RV or an interest in RVing!
If you have answers, please help by responding to the unanswered posts.
Kings road area Phone service, internet ?? Where is nearest dump, water ? What , where is the Desert Bar? Visitor Center?
Anything else appreciated.
Thanks , Pat
A belated thank you, John. I called customer relations and got an answer in about 5 minutes. A correct answer no less. The controllers are in the rear of the compartment left of the entry door.
PAT
We want to move the dinette table out from the wall and add a bench at the wall. I need to put some legs under the table that will be stable. I'm thinking of attaching legs to the bench but that will restrict use of the bench. Any suggestions?
Thanks, Pat
Winnie 2010 Vista 26P. Power Gear / Lippert below floor worm gear.
The passenger side bedroom rear slide was sluggish and needed a hand to extend or retract and is now stuck in the in position. I lubed it while extended and retracted it ( worked great, snugged right up to the body). 3 weeks...
I bought LED lights to replace the 921 base auto lights used in all the ceiling light fixtures in my RV. Each fixture currently holds 2 lights. The LED's are 3500K 1.8 watt 215 lumens. I bought them primarily to get a warm white light as opposed to the very bright white light of the original...
I found the replacements on M4 and E trailer . There are also 3 wall mtd. fixtures with a round lamp ~ 1-3/4 inch diameter. Each has 12 led bulbs. I cannot figure out how to get them out of the fixture. I assumed a screw in base but that is not working.
Suggestions?
Thanks, Pat
2010 Win. Vistaisting
I want to replace the interior 12v ceiling light bulbs with LED, less bright and warmer. I have had no luck in finding LED bulbs at local stores, auto parts, bulbs and batteries etc.
Suggestions ?
Thanks,
Pat
I want to protect battery post and cable terminals from corrosion .
I was planning to use dielectric grease but it seems that is not conductive so not the thing to use.
White lithium grease?
Thanks in advance,
Pat
Thank you Gary, The micro is 800 watts and we typically run it for 3 minutes in the evening with no solar recovery and 3 to 4 minutes in the early morning with solar recovery beginning 1 to 2 hours later.
2010 Winn. Visa 26 class A.
960 watts solar , 4 - 230ah 67~volt , s/s/p. 3000w inverter.
When I run the micro the voltage drops to 11.78. This is with a 90% + soc. If daytime with solar operating the voltage quickly returns to ~12.7. After sundown this is more of a problem and slower to...
Thank you all for your responses.
No one has replied to my question about 2 additional batteries lessening the voltage drop when running the micro.
Thanks,
Pat
2010 Winn. Vista 26' Class A.
I have 4 Napa 6v 230ah batteries 2s/2s/2p. 960 watt solar with a 3000 watt inverter/charger. 4500w Generator.
I know very little about batteries or electrical.
Last trip out the Victron battery monitor began flashing and beeping a low voltage alarm at 12.17 v...