Recent content by Capt.Tony

Yes they absolutely did check the front axle. It was ok.  I was also surprised they removed it and asked the mechanic about it. His response was that there is a right way and a wrong way. Carry on.

To those that responded i have just returned from my appt at Fl Spring and axel. They removed the axel and straightened it out. It had a 1.125?  toe out bend in it.  3 hours and 380$ later i,m good to go!  Did it work? I have no idea.  Felt smooth and stable on I-75. But it felt that way with...

To those that responded i have just returned from my appt at Fl Spring and axle. They removed the axle and straightened it out. It had a 1.125?  toe out bend in it.  3 hours and 380$ later i,m good to go!  Did it work? I have no idea.  Felt smooth and stable on I-75. But it felt that way with...

Yes, i see it now on the map..i,m contemplating just getting a rv site somewhere near denver and andd leaving the 5er there for a week and drive the puller to Pagosaw.. I really appreciate your respownse. ASTravelers

Our annual pilgrimage to Glenwood Springs this year will need to be cut short in orderto visit with Family who are visiting Pagosa Springs .  We have a 32 Ft Cougar 5er that i pull with my Silverado 3500 1 ton sinle rear wheel. So far (6 years ) I haven?t had any issues driving on I -70 thru...

I replaced the tire today and have an appt at Florida Spring and axle service in the morning. Keeping my fingers crossed and a positive attitude that they?ll resolve it quickly, efficiently and inexpensively. ?. ThankYou to all that expressed an opinion.  Will give an update as to the resolution.

Gary, its worn only on the inside of the tread around the perimeter of the tire only. The outside 75 %. Is normal.    I took an 8? straight edge and held across the face of the 2 tires and the front portion of the 2x doesnt touch at all , in fact there is approx 2? gap.    Thats a lot of bending.

Hello Pros..  Ok  1 year old 5th wheel, prepping to take off cross country after a long layoff after Hurricane Irma......  Checking tires and pressure and i find 1 tire on the rear  axel passenger side , that is almost worn thru.  seriously, i have no idea how i didnt have a blowout.  Any ideas...

Thanks GIZMO :o, there were no wires there.  Snaked what i needed from the bath fan. Not a big deal.  Finished the entire install, including removal of the old vent and the self leveling caulk in 4 hours working alone.  Worst part is removal of the dicor caulk... Terrible Done and looks/ works...

Today i used a fiberglass fishing rod to snake the wires from the bath fan that had power to the kitchen vent that had no power. It was actually very easy and only took a few minutes. 8)  Tomorrow i will remove the vent from the roof and install the new fan, wiring and the whole caboodle  :) . 

:) Rene T...... I do have a tester. I purchased it to sort thru the wiring of my water heater in my old Cougar. I'm set on doing this myself. Trial and error until i get it done the way i want.  I checked the entire accecibel area around the vent hole, there are no wires other than the ones that...

  Hello forum,  I just purchased a new 5th wheel and the vent in the kitchen ceiling is non powered and too high to be opened manually without a small ladder. I wish to install a remote controlled fantastic fan in the same opening.  There is no pre-wired power for this , however there is a...

Ok , So, Now i have purchased a Multi Meter and made the final connections.  So i test it out and low and behold i have SPARK.....  No Ignition.  Any suggestions other than make sure the gas is on??  Thanks.   

Thanks YOLO

Hi Gary rvroamer    The new suburban has red, blue and green like i stated in my original post, also the black and white 120 power wires.  I will try to trace the 12v as soon as i get a tester today.  The trailer mfgr told me straight out they could not help, to call a dealer....and then the...