Recent content by Dave78Chief

Getting back to you original question: "If I add a separate solenoid to isolate the battery, does anyone know if I can wire it into the existing house battery disconnect switch so that it would operate at the same time the current system is disconnected from the battery?" Your existing Battery...

MH Chassis is not your best choice for this application.  You should be looking at doing a School Bus Conversion.  Front half living section, rear half shop area.  Warning though, school bus metal is real heavy duty. Dave

First, yes there is a check valve in the 2.8 gph Shurflow pump.  Your operators manual even says that on page 7-4. 2nd, yes the 2.8 gph Shurflow pump can be rebuilt.  Repair kits for that pump can be found on the internet.  They are also listed on page 112 of the Winnebago RV Parts and...

Because motoraid heats both water heater and rear register, water is allways flowing through hoses (no valves along the way).  Hose to water heater input connects to a tee in the intake manifold to front dash heater hose.  Water heater output hose goes to input connection on rear heat exchanger...