Recent content by garysu

Thanks for the input. Think I'll try on my own for awhile longer. May go with rvt or rvtrader later. Thanks again, Gary

I put my Class A motorhome for sale on Craig's List and received a call from "isoldmyrvhere.com". Like most they sound to good to be true. The question is, has anyone here sold or bought a motorhome through them. They claim no commission that they make their money with finance charges.

Turn engine off and turn the key to acc.

Does the air pressure also take care of the washer/dryer or does it take a special procedure? Do you turn it on, and put it on spin cycle so the water gets out of the lines and then put the pink antifreeze in the drum? Gary

Jeff Thanks, I feel much better now.That totally makes sense. Gary

Bernie, The  unit is a 2006, but it's new in the sense that it had never been sold. It has about 3500 miles now but was around 2500 miles when it over heated. The coolant and radiator look as if it just rolled off the factory line. From what I read this is a FL XC chassis problem. I think the...

I purchased a new 2006 dp in July, 2009. It has a cummins 400 ISL eng. with side radiator.I had a coolant temp alarm go off going up the moutain on I40 between Old Fort and Black Mountain NC headed west. It was at the top and the alarm went off within probably 10-15 sec. I thought the...

Ned and Gary, Thanks for the info. I'll pull the cover today. Gary

I traded my gasser in on a pusher and trying to find the serial # for the engine. It's a 2006 Mandalay 40F with a Cummins ISL 400 HP. I've crawled under the engine looking for this serial# without success. Any help will be appreciated. Gary

Bill, Thanks, that was a great help.. Gary

Thanks Mark, I talked to tech support at Actia. He gave me instructions on how to check the dianostics for the cluster. The cluster worked fine on the dianostics test, so it's the sensor or a loose wire. Gary

Mark, Thanks for the reply. I would very much like the number and address. Do you have any idea of a time frame, I'm planning a trip for the end of May. Thanks again for your response. Gary

My temperature gage does not move (stays on cold) until the gas gage registers 1/4/tank. At that point it will go to hot and will alarm. Put gas in and it goes back to the cold (as far down as the needle will go down). I've called workhorse and they tell me I need a new cluster. At $600.00 after...