Recent content by JDMAG

This is a laundry additive. it comes in small bottels to be added to the washer like detergent. There is a liquid (which I used) and also powder.

I actually have a dump that goes to my septic tank at home.

I just did the Geo method. didnt even move the TT just let it set for about 4 days and dumped. problem went away. nice clean and clear flush. then I did the grey water tank too. no problems any more. Thanks for the replies!

Thanks guys. I'll give some of this stuff a try.

I probably already know the answer, but is there anything that will just keep the wasps from building nests in all the little places like around the water heater, and fridge, and any other accessable nook and cranny on my TT? just askin. they seem to be every where right now. :o

tru DAT!

Floorplan,floorplan, floorplan! A stove/oven, Microwave,bathroom, Sink, and TV,all come in most every thing from a pop up to one of them there BIG motor homes with a little car hooked behind it. but if you don't have the design that fits you, then you wont be happy. My old toy hauler was great...

not this model, but I had an 03 Keystone Hornet toy hauler and I had no troubles with it.

Cool! 8)

mine has a switch on the monitor panel for the water pump, gas water heater, and the electric water heater. I dont know what happens if I switch on both. I hope one would go off. ? might have to try that later. ???

Thanks for the advice. I have to leave town for a few days this week so I'm gonna try the Geo method, and let it set while Im gone. then shake it up and drain again.

thanks! that was a good read and informative. I'll get some calgon and fill the tank and let it set while I 'm gone to work this week.

My black water seems to be stuck on 2/3 full. I found this out when I was flushing the water systems. I put the bleach and water solution in the fresh water tank for a couple of days, and then ran it thru the grey water tank. since I was hooked up to dump, I ran some water thru the toilet also...

The Breaker may be weakened from all the trips.The original problem may have been the loose wireing, and there may be more. And it may not trip after replacing. However, I would do as Ned said, and test each circuit at a time.

MTFBWY .......... May the force be with ye! lol ;D