Recent content by NoMoreAZ

Since I reported this problem, I did some 'de-tuning' of a browser and found the problem. 'witclub' and 'winnebagolife' still requires a browser have TLS 1.0 enabled. This version of TLS (Transport Layer Security) is not secure and not recommended by any knowledgeable source. Using you favorite...

Not a VPN problem. Fails w/ or w/out. Link on this thread fails. Link from winnebagoind.com fails. Using a search engine to find 'WIT', site is located, access fails.

Details = Win 7 or 8.1, Primary browser = Pale Moon 28.1.0; BU browser = IE11 with latest maintenance. Attached errors: Problem Loading Page = Pale Moon; tlserror = IE11. Always thru a VPN.

John, Can no longer access WIT site because their SSL authentication is so far down level that my current browsers will block it. Can you check with your contacts about this? Thanks.

Replace original screws attaching duct work to unit with hex head screws. Works nice. Easier to remove when you remove unit next time!! I also replaced all weather stripping around duct where it attaches to unit with something thicker and a bit wider than what 'Bago used. Got something at HD or...

Our ODO suddenly picked a number from somewhere many years ago when I started the coach one day. I now have about a 52.2K difference between what the ODO states and what the MMDC says. I log in to the MMDC in diagnostic mode periodically to see what the latest delta is. I have a letter signed...

Saw in Escapees Forum that the SD address is in Box Elder, SD. I hope it's not America's-Mailbox that is doing this work for Escapees. Have seen bad reviews of that MF operation. IMO, owner seems like a carnival barker, snake oil salesman, etc. Will have to call Escapees about how this back and...

Original foam gasket bad here also. Used MD Premium Sponge Rubber 3/8T x 3/4W black, comes in green bag (still I think). Can find at HD or Lowe's. Sticky side to, in my case, plastic ductwork that attaches to HP. After ductwork attached to HP, taped all around with foil tape. One may wish to...

As promised... The instructions are listed in numbered sequence. If I do this it this way is easier for me to follow. Considering your UID on the forum, the numbers at the start of each step have been adjusted accordingly. This travel latch installation was installed on a Frigidaire LGHT1837N...

Will do. Should have something put together by 4/9/17.

For top... Fiberglass batts, or foam board; outside remove vent cover and use spray foam if desired. For side... Metallic tape used inside the door to seal all the openings completely. Gray pipe insulation, trimmed, between the ridges, etc. Makes a neat job. Also think how you are going to...

Me too. Got confused by which lights you changed. Just wondered about the switching pwr supplies.

DTNA supposedly changed that a few years ago. CS said 'my information got detached from my account', whatever that means. Anyway, I'm back in business. Jeff, I sent you a PM.

Also, if you have or request a login to DTNA (Daimler Trucks North America) the follow on to AccessFreightliner, can get the drawings there. I just tried my logon, but it seems to have disappeared! So I sent DTNA an email.

Why not GPL-4CT? 6 volts. I have 4. 220 amp-hour discharge rate at 20 hour std. So I have 440 amp hours. Weight difference = 42# more. 65 more amp hours. I believe we have the same size Kwikee battery tray.