Recent content by oldcrow

The friendliest place on the web for anyone with an RV or an interest in RVing!
If you have answers, please help by responding to the unanswered posts.
  1. O

    Need Help Locating Vacuum Lines for AC Control on Voyage 32H

    I checked with a couple repair shops and no one had any info on the vacuum lines for my 2003 Adventurer 35u . I started tracing out the lines and found a few with only half of a line left. I ran my fingers down each line and if I found a rough spot I repaired the line with windshield washer hose...
  2. O

    Winegard carryout G 3

    I purchased a Winegard carryout G3 to use with my 2003 Adventurer .I am having a problem with  the wiring from my DTV HR54 receiver to the 2003 RCA tv . The HR54 has hdmi port  and the tv has rca ports. Is there a converter for this? Also do I need a power insert and multiswitch kit to make it...
  3. O

    Limp Mode

    Thanks Richard for the reply . I decided to replace the TAC , Throttle body ,plug wires with ceramic and o2 sensors. I hate to just throw parts but it is a strange problem and I know it will be a fortune at a dealer. I noticed the plug wires were replaced twice in 18545 miles that tells me...
  4. O

    Limp Mode

    Thanks for the info Arch  I am still working on it. I talked to a mechanic today and the first he thought was oxygen sensor . The reason he gave was it sounds like it is heat related ( because it will restart after 5 minutes and then run fine ). He thought it may be something high resistant that...
  5. O

    Limp Mode

    Arch      Yes it does.P1516 and Po151 
  6. O

    Limp Mode

    Tony  I am stumped as well. I don't know if that is normal when it goes into a limp mode or not. It did turn right over and started when I stopped and let it set for a 5 minutes. All power came back and went on down the road. I am going through and cleaning all grounds I find from the batteries...
  7. O

    Limp Mode

    Emiddled  I will check out the plug wires . I see in the past inspection 2014 the wires and plugs were replaced because of a dead miss in the motor . I am the second owner and the original owner had all the inspection and repair work papers. We live in Virginia and inspection is done every year...
  8. O

    Limp Mode

    Gary  Point well taken
  9. O

    Limp Mode

    Hello Arch, That was the first thing I tried  new filter and cleaned map  and made no change . I don't know if the P1516 code could cause the P0151 code. What happened to the Good Old Days when didn't have all of these codes and crap? Thanks for your reply
  10. O

    Limp Mode

    Hello everyone, I have a 2003 Winnebago Adventurer 35U on a a workhorse chassis 8.1 motor with 18545 miles. When I first drive the motor home it has good power and runs like a top. When I stop for gas and let it set for 1/2 hr or so it starts up very rough and won't take the gas. You can't...
Back
Top Bottom