Recent content by schoolsout2

A 12 volt line is added direct from the Barrera for the brake system.  I also have a charge line from the MH to the toad to keep it charged.

Thanks for the reply Gary.  The question was about the toad wiring.  This is the first time I used diodes and was having issues.  A camper down the road had a Ford Edge and he said he had issues until the disconnect was put on the positive post. After reading your response I said DUH!  If...

The edge manual states that the negative battery terminal needs to be disconnected.  The Rv dealer put in a disconnect and a set of diod lights.  The lights quit working.  I am now told by a fellow edge owner that diode lights will not work unless the positive terminal is disconnected. Why is...

I just swapped my Winegard Rayzor 8500 for the Jack 8300.  I went from 12 channels to 27 sitting in the same location.  I could never get the Rayzor to work after a few times.  It would not rotate.  I went through 4 of these, but only purchased 1. Former owner had the batwing post and crank...

Along the roofline on my Tour,it appears the clearcoat is pealing off.  This is above the rain track where it rolls up to the flat roof.  Is this common?  Can I do a light sanding and spray a new coating on?

I have Accuride.  They polished up real nice.  Now covered for the winter.

Thanks all. I will try the viegar, otherwise just some polish.

I need to spiff up my aluminum wheels.  I am using Mothers Aluminum and Wheel polish.  They are  amp ice and shined, but there are what look to be water spots still there.  Any good hints on getting these spots off?

1500 miles in 7 days?  That will be about 5 hours on the road 5 o 7 days.  Plus setup.  Makes for short visits and not much time for fun.  Hope the 1500 is round trip.

Thanks, job done.  They were not very bad.

Is there any cleaning that should be done on my air conditioners.  I plan to take the covers off and clean them off but wonder if there is more I should do. I read an article that stated the Mach air can not be recharged.  Is this correct?

Similar problem in our MH.  Cleaned shore cord terminals.  Maybe it will work for you.

The problem only occurs intermittently after I use the pump.  To stop it, I cycle the pump on and off.  Thanks NY_Dutch, I will look for that part.  I will put in the valve for now.

My water pump is letting water flow through and is filling up and overflowing the fresh water tank while on city water.  I plan to it a check valve in line to stop this.  My understanding is the checkvalve in the pump sticks open allowing this to happen.  Instead of $200+ for a new pump this is...

I believe you want it onwards the rear of the MH.  It boost the signal from the rear transmitters.