Recent content by SPSchaller

Thanks Everyone.... Flow bottomed out again last night, so I've ditched the old regulator and purchased one similar to what Ohiosnowbird recommended. The issue has been eliminated at the moment but I feel I'm on the right track. I've replaced the canister filter at the spigot and plan to...

I've been reading the Forum posts regarding issues with low flow when using inline pressure regulators and I've come to the realization that the cheap one I'm using is likely part of our problem with low flows at the sink and shower. However, our problem is inconsistent and I'm wondering if...

Clear Coat... That didn't cross my mind... I noticed its showing up in other places as well so guess we'll just live with it... disappointing, but it is an 18 year old, entry level motor home. Otherwise, it looks pretty good, so I guess I'll just keep waxing the heck out of it, and tell folks...

I've noticed some areas on one side of my '05 Bounder that have become discolored and above one of the windows its bubbly and peeling. I wax at least once a year, sometime twice and always use a wash that has wax in it. I'm curious what might be causing this and if there is a way to fix it...

A piece of trim has come off the corner of one of my slides ('05 Bounder). Fortunately, it fell while we were parked so I have it. I am unsure how to reattach it. I am assuming the old adhesive will need to be removed first and new applied. I don't want to experiment with just any adhesive...

I appreciate the replies... wasn't sure I'd actually get any... so Thanks to All. My healthcare is through BJC/Washington Univ. in St. Louis. I spoke with my PCP who suggested I research area hospitals in central FL with outpatient clinics and then coordinate with my rheumatologist. I suspected...

We've been RVing for many years and for the past few, we've wintered in central Florida. Recently, I've developed a medical condition requiring Infusions every 4 weeks. I have been researching how I would go about obtaining these while in FL (we live in Missouri) but haven't found much useful...

I wax my 2005 Bounder a couple of times a year and on one side, the driver's side, I notice inconsistencies in the shine that simply have me curious. I suspect that there are support structures in the sidewall in the areas where the shine is glossier, but I can't think of why this is occurring...

Doing some cleanup on our 2005 Bounder 33R. The kick plate below the entry door is cracked and disfigured, and we'd like to replace it. I am guessing removal could be done with a heat-gun and maybe some heavy duty fishing line, although I am open to suggestions. What to replace it with would...

A little late getting into this discussion, just found it... Sorry for your Data Loss, Ed... It sounds to me like your initial problem may have been a hard drive failure affecting your boot sector. A system restore should have been able to back out any recent update had it been simply a software...

Thanks for the warning, John... I used a simple circuit tester designed for live circuits as I just wanted to determine if there was any juice at all going across the replay. And Thank You Gary for the update. I may bypass the EMS for the time being until I find out if I can reset the relay...

I believe I have identified the source of the problem. As recently suspected, it appears to be one of the relays on the EMS board. I tested for current across the relay and there doesn't appear to be any. There is current going into the board, but none after the relay. The other relays on the...

Thanks Gary... Its marked as Refrigerator... anyway, tested the breaker and its appears OK. Today I'll test the continuity of the romex since I can't follow it under the flooring. If OK, I'll have to assume that its an EMS issue. Its starting to make sense, though... it was working great on the...

We are home for a while so I am continuing to work out why no power is reaching the duplex for the refrigerator. I yanked the duplex and check internally for current but there wasn't any, so I don't think its the duplex. I traced the romex to under the frig (what a mess) to where it goes into...

I did attempt to pull the duplex to check the connections and voltage on the wires, but its pretty hard to reach and the duplex is not a normal box and I couldn't get it open during my attempt. We leave for another destination in the morning, so as a work around, I've run another cable to a...