Recent content by steve-n-sueC

I'm looking at a 2013 Tiffin with the Cummins ISB 6.7-liter Electronic Diesel, Turbocharged, Aftercooled Engine. This will be my first diesel, so naturally I'm a little bit concerned about the DEF head problems. Any comments on this combination? Is the DEF head an issue on it? Should I be overly...

Just as an FYI, the OEM part number for an oil filler cap to fit a 2008 Adventurer 38J with the 8.1L gas engine on a W24 chassis is 12574265 , which will cross to a (NAPA) Balkamp 703-1380. We cold not find a listing for that specific application, but finally found this one which will fit.

The plastic batten strips that divide the ceiling into sections, I assume just clip into place. Has anyone ever removed any of them? I need to take one down to re-fasten the sagging ceiling panel. Thanks in advance for all help!

Resurrecting an old thread, here. My 08 Adventurer 38J wipers work perfectly at a stop or slow speeds. When I drive over 50 MPH, or there is a headwind, the driver's side wiper will go completely off the glass, and stay there till I stop and push it back in place. They have a normal range of...

    OK, many thanks to all for your thoughts, opinions, and explanations.  I should have known that there are some photography experts on here, same as any other subject!  LOL!     I did pull the trigger on the refurb Canon PowerShot SX530 HS. Been playing with it for a few days. So far the...

    Ok............  Against my,(and everybody else I talked to,) better judgement, I decided to remove the clear body mask from the front of our 08 Winnie Adventurer 38j. It had a couple of visible impacts from road debris, and several places that the adhesive had mold, behind the film...

Being a very energy conserving individual, (LAZY) I have started using a permanent marker to mark the size of the oil drain plug somewhere in the engine compartment, to eliminate two or three trips under the rig when I change the oil. I write it on one of the rubber flaps where it is obvious. I...

Thanks for all the replies, especially allenb12. I looked at the Canon PowerShot refurb that you recommended and it looks very good for the $$.  My only concern is that it is an electrical zoom, which a couple of others do not recommend. But the reviews I have found are good, and I'm probably...

The best source I have found for Winnie parts is Lichtsinn Motors.  If your awning has auto out and in, versus having to hold the button down, I believe the control box monitors the amperage draw of the motor, and shuts off at a predetermined amperage, thus not having to hold the button. I don't...

We are going to scratch off one of the big items from our bucket list this fall, by attending the Albuquerque Balloon Festival.  That said, I want to buy a camera instead of trying to take amazing pictures with my cellphone.  My requirements are:   Digital   $200 range or less   must take...

I had a glass shop build me a replacement glass for one of the small sliders in our 08 Adventurer 38j. I was able to get the old slider out of the frame by reversing a bar clamp and SLOWLY spreading the interior edge of the frame enough to get it out. Once out, it was a matter of getting the...

We recently replaced the short queen Sleep Number mattress that came in our 08 Adventurer 38j, with a custom built short queen from Personal Comfort.  It is considerably more expensive than those you were mentioning, but I have absolutely no regrets, after sleeping on it every night for three...

Searched the threads and didn't see anything similar to this, so thought I would share my experience with those who might find themselves in a similar situation. We were having trouble with the timer not advancing on our Splendide wd2100. Called Splendide tech line, they diagnosed it as a bad...

But as Father Time marches on, I find myself learning the same "new things" rather frequently!!!!!

What is the proper terminology for the "multiswitch"?