Recent content by Acman44

The friendliest place on the web for anyone with an RV or an interest in RVing!
If you have answers, please help by responding to the unanswered posts.
See posts with no answers
  1. A

    DIY build

    Thanks all, I've ordered some knipex crimpers and ferrules for the job.
  2. A

    DIY build

    It just has the screw in contact with the wire (no plate). I thought about soldering but many say not to.
  3. A

    DIY build

    I am hooking up the breaker panel and need some guidance. The panel is being fed by 10/3 SO cable. My question is can I or how do I connect the fine stranded wire to the breaker and neutral / ground bars? It's a small panel so not much room.
  4. A

    Power Converter hook up without batteries

    All wire is THHN
  5. A

    Power Converter hook up without batteries

    So I got the converter hooked up, now I have another issue to figure out. I have a 12v dc circuit for the water pump that runs approx. 97 ft round trip to the distribution panel. The problem is its mixed with 10ga and 12ga wire. The pump is 13A max. I know the 12ga won't handle 15A at 97 ft...
  6. A

    Power Converter hook up without batteries

    What are the other reasons you would add a chasis ground?
  7. A

    Power Converter hook up without batteries

    It's a home built toterhome.
  8. A

    Power Converter hook up without batteries

    There is no chasis ground inside distribution panel. All component grounds return to the panel.
  9. A

    Power Converter hook up without batteries

    I have installed a new pd9200 converter in a rv with no coach batteries. My question is how to hook it up. Do I just run the -DC and +DC outputs to the fuse panel and ground the case to the chasis? Or do I have to run the -DC to the chasis too?
Back
Top Bottom