Recent content by Deac3967

That is correct here is the treaded reducer 1 x 3//8 NPT.

I have a 1996 Holiday Rambler Endevor with a onboard generator. The generator was loosing coolant I started trouble shooting the issue. Her is my findings on the block (see pictures attached ) I find a pitcock valve leaking at threaded connection into block. I attempted to remove it to my...

Had a little mishap the other day with my 96 Holiday Rambler Endevor LE. Damaged rear end cap and bumper and bumper trim. Got a quote from a bone yard dealer in kY for the parts. A whopping $4000 just parts no shipping does this sound unrealistic. Is this par. Has anyone on here have any...

Sometime I'm my worst enemy. That being said. Started out when I bought my 96 HR the speedo did not work. So I was instructed to check input speed sensor on my MD3060 trans. While checking for shorts in the wire I pushed my meter probes into the female side of connector. Not realizing it opened...

I have a 96 Holiday Rambler 5.9 cummings with a Allison Transmission MD3060. Shifter is showing a 2214 code. I've removed the input speed sensor cleaned it reinstalled it . I have ohm it out manuel says 300 ohms it reading 322. I've also swapped the input and output speed sensor. I cleared the...

Its stuck at 65 MPH you can move needle back to 0 it will revert back to 65 as soon as you turn on ignition switch. Maybe stepper motor.

Original speed odometer quit working tac and all other gauges are working. I replaced the speedometer with a GPS with stepper motor. Reconnected all wiring with exception of signal wire now. Transmission shifts fine going up downshift a little hard when slowing down could changing out speed...

Hey guys I fixed the amber clearance lights on front of my HR. Turns out a bad ground to the lights wired in parallel series. Ran a new ground and they work great now. Thank for all who replied.

I checked bulb with meter read good did check for voltage 12V DC none. Put bulbs in a working side marker light filaments came on.

1995 By Freightliner.

Dash lights, side marker lights reear clearance lights all working. Cab clearance lights not. Tried using a wire tracer to find the wiring for those lights. Bulbs are good. ICC switch not sure if it's working. 96 Holiday Rambler Endevor Le any ideas where those lights gets it power.

It'sa cummins 5.9 B series motor 230HP

Want to install a Scangauge D to monitor my motors performance. Lookin for the Diagnostic port on A 96 holiday rambler endevor LE turbo diesel. Should it be a j1939 or j1708 pin plug all I can find is a plug like that of a OBD 2 with a cover stating Diagnostic use only. I need to adapt from...

96 HR Endevor does anyone know if there is a blower relay or fuse for blower motor and its location. What is considered front run bay.