Recent content by itchn2go

On my 2005 Journey, the door awning refuses to come out. I do hear a clicking in the storage compartment when I push the button. Any Ideas, thanks

Not unusual, but if some of the items come under "piddly" the dealer will most likely not want to deal with it. Took me bout 2 years to get the bugs outta a 03 Horizon bought new. Since then have bought used and had very few problems...Happy Trails

Charge your batteries to full charge with the exterior charger. Turn off all power drains by using the switch on the dash..I did this and my batteries held the charge just fine..the detectors etc have a enough drain to kill the batteries over time and a couple of tenths each day...Just sent my...

A piece of carpet cut to fit the dash will do the trick. I cut a pattern first then cut the carpet. Fit nicely and sure protected the dash from the dogs nails...Lots of choices in carpet as to color and thickness. Good Luck

Is there a easy way to test these fans to see if they work satisfactoraly??

The roller itself is what has the slight bend. Thanks

The slide topper roller on the drivers side slide on my 05 Journey is bent in slightly ,  in one area of the roller about three feet from the front. This causes the topper to roll out jerkily(?) in the spot and causes the slide to jerk out and not go out smoothly. It comes in just fine. I must...

I have never been to the factory. However I have been on forums since 03 and have followed the posts of some ole timers and I do believe that Winnie in fact discourages factory pick up. Lichtsinn has a great reputation but you already have a dealer and I would have a written understanding that...

If you can't get the answer from the salesman and if the forum can't help you, always do as you did call Winnie. They will most often tell you what is right. And remember if it sounds fishy it usually is. Most of the forum members are knowledgeable but Sicssor(sp) Jack John has all the toys...

The dinette slide on my Journey 39K bumps and jerks its way out. It starts out smoothly for about a foot and then it bumps and shudders the rest of the way out. It comes in just fine. I have cleaned both the arms with a fine scouring pad and lubricated the rubber around the slide. Has anyone...

When I extend my drivers side slide. It starts out very smooth and before it is completely extended its doin a little dance. Jerky/jumpy like it is hangin up on something. Cleaned the slides with scouring pad, very smooth and then lubricated with silicone. Same thing, but maybe not quite as bad...

My tale of woe: Not brand specific. I was advised I needed metal valve stems on my toads wheels as the rubber ones were to flimsy. Called my local backyard man who had sold me the tires and told him I was installing a TPM and needed metal vale stems, sure it is a easy fix, bring it down. Rode...

Shudda known,,,,done that on drawers for years...Thanks

The sliding windows on my 05 Journey 39k are very hard to slide back and forth to open or close. Has anyone dicovered a way to make them slide any easier? Some kind of lubricant in the track? Thanks for your replies. Be Safe

Wow,, the bleeding is serious. Does the lysol work for that too? :'( 8) ;D :)