Recent content by torgyg

Well I'm back again. While looking at the item pictures from the above NAPA web site i do believe there is a problem with the plug fitting into the fan sensor. the FS104 has a divider between the two sides and the plug doesn't look as if it has the slot required for it to bottom seat.  So now...

A Very big thanks to all who replied. Ill be visiting my local NAPA store in the morn again.

Maybe someone can help me out I just replaces the engine water temp sensor on my 97 Itasca P30 454. The one that is on the right side of the engine in the cylinder head. What I now need is to find a replacement plug as the old sensor and wire plug broke due to heat I'm guessing. this is a single...

I replaces my 20 CRT in my 97 Itasca with the plastic trim. Found that a 24 in Vizio razor fit just fine. Had to trim the inner edge of the trim to fit the shape if the Vizio.I can try take some pictures and post for you when i get a little time.

Alt has already been replaced, I've removed it twice so far and had the new one tested , works fine on the bench  >:( I still wonder about the isolator. Chev Motor Home chassis service guide shows one in the system , even tells how to test, but does not give it's location. Boy talk about getting...

Thanks to all who answered. I guess i was in too much of a hurry on the first post. The problem is not with the house batt's , but the eng. bat. The eng alt is suppose to be able to charge the house bats while you are driving, at this time none of the bat's are being charged. The manual refers...

I've been reading all the messages about the batt. charging problems others are having, Well I'm having one also . For now does anyone kno0w where the red Pos. wire form teh 12 volt alt. runs to ? I read in the manuals about a isolator some where that is suppose to monitor and direct the charge...