13398-D dual motor control

[molly4444]

Replacing my motor control. What I see online, looks like the new model controller needs plug in wire terminals.
My existing controller has separate sockets ( lock screw type) for each wire. Any advice on where to get proper connectors would be greatly appreciated.
Thank you
Bill

 

[NY_Dutch]

I can't help you with your connection issue, but it would probably help to note that you have a Lippert slide system that uses the controller. Hopefully someone with a similar system will be able to assist you.

 

[John From Detroit]

Replacing my motor control. What I see online, looks like the new model controller needs plug in wire terminals.
My existing controller has separate sockets ( lock screw type) for each wire. Any advice on where to get proper connectors would be greatly appreciated.
Thank you
Bill

Send link or photo of new/old controllers.

Very good chance you can get the proper connector .. Or make it.. I recently needed a special plug. Only upon investigation and testing.. Turns out I did not need a special plug at all.

 

[OldWEB]

Manual
Best I could find, Calling Lippert may be the best option.