DonTom
Senior Member
RV LIFE Pro
Do ya think a screw fell out?That looks like a warranty issue more than a wind issue!
Do we know Rachael?Rachael

I think the plastic cover around the motor broke. Look closety at the middle photo above where you see the wires. The plastic looks uneven there as if it broke.It looks like the wires just pulled connectors apart so that would be easily repaired. Can you tell what came apart, as did something break or perhaps a bolt sheared? Is there a chance you could put it back?
May not be worth the hassle in my case. IIRC, I have a 5K$ deducible on this RV. I don't like giving them more than I need to. OTOH, I am not expecting stuff like this to happen so perhaps that was a mistake.Contact your insurance company, I've had two replaced due to a wind incidence.
The good news is the front has passed us and the weather channel is predicting 7-8mph winds overnight and into tomorrow.For now, I will just have to hear the roller for the awning bang against the RV all night unless I can find a way to secure it.
-Don- Mayo, FL
I am okay for tonight. I just put my ham radio antenna case between the two on top of a small motorcycle jack. It keeps enough space between the roller and the side of the RV so it no longer bangs with the wind gusts. It's nice and quiet in here now.The good news is the front has passed us and the weather channel is predicting 7-8mph winds overnight and into tomorrow.
I'd hate for the awning roll to damage your RV sides. If you think that's a concern and have some rope you might tie it out to your bike.
If you really need to I could bring some stakes and rope tonight and we could stake it out - Let me know. I should be online for another hour or so.

I have yet to see another Vision on the road or in any RV park I have been to. Are these rare or what?Oh my God…….
Flashback from our last trip from North Carolina to Texas.
First night, water accumulation got the upper hand on us. Major pooling, and kaboom…..
Talk about flashback, we run a Entegra Vision just like yours.
We were able to save the spool and fabric, lost both arms.
Amazon to the rescue when we got home.
This RV has three beds, the one above the front driver and passenger seat, the sofa bed and a King bed in the rear. Yes, a small slide for the dining room which will make room for the sofa bed and increase the size of the walkway. A large slideout for the king bed in the rear. This is 29' 11". An inch under 30 feet for a place that only allows less than 30'. But my motorcycle rack adds a foot or two to that.I think the 27a has the bunks, looks like double slide.
29s 31-4”, single full side slide, no bunks. Outside kitchen.
We never seen one on road yet.
We hooked ours in 2019, only two on east coast at that time, one is in our driveway.
After the night from ****, next morning wife and I slid the tube and fabric together off roofline track.
Put though rear bedroom window and down center of floor for balance of trip, pain in *ss.
Ordered new arms when home.