Battery Charging Problems

[John From Detroit]

That sounds so darn like a new-fangled "glue gun" I have seen... just have not got around to buying one yet. :-/

Glue gun is a bit different as the PLA I use does not stick well to other than PLA.. But the pen does work well for some stuff. I use it to repair PLA prints and for some TPU prints I need where I need to wrap around somehing.> Can't do that with the printers.

 

[OldWEB]

I had to look them up, so for those of you that do not know...

TPU, or ThermoPlastic Polyurethane
Polylactic Acid, commonly known as PLA

Me thinks a 'glue gun' is understandable and easier to use, some day I will buy one.

 

[John From Detroit]

I had to look them up, so for those of you that do not know...

TPU, or ThermoPlastic Polyurethane
Polylactic Acid, commonly known as PLA

Me thinks a 'glue gun' is understandable and easier to use, some day I will buy one.

I also use PETG (Water bottle plastic)

TPU is rubbery and flexible.. I made a crutch tip with it.
PLA is hard but softens at hot water heater temps.
PETG well the bed print when I printed something yesterday was 70ºC (158ºF) So even dishwasher temps should not soften it. (Nozzle temp was 215C that's over 400F)

 

[chuckbear]

And this has to do with battery charging How??????? Chuck

 

[Onyrlef]

Maybe a stupid question, apparently pulling the old solenoid and getting the new back into place was the difficulty. Why did the solenoid have to go back into the original location, why didn't you just tie onto the existing leads leaving the old solenoid where it was and mount the new somewhere else?