Keyless Entry I/O Learn Module

[SeaNuts]

I have a 2008 Mandalay 40G, looking to reset the Master Code and need to find the I/O Learn Module to short out S1 pins.

Reset the keypad to the default state by performing the following procedure: • Cycle (short then open) the S1 pins of the I/O module learn connector. There will be a three-second beep. • Enter a new five-digit code; this will be your access and authority code. • Enter the new code again. • The existing code will only erase if you properly enter the new one. • The code is stored in position one.

I don't know where this module is located, any help at its location would be great.

 

[Gary RV_Wizard]

Sorry to see no replies - I guess nobody around here at this time has your year & model.

 

[SeaNuts]

Sorry to see no replies - I guess nobody around here at this time has your year & model.

Thanks Gary for the reponse.

 

[Tom55555]

You can probably replace and update the whole system for $150.

 

[SeaNuts]

I found the module next to the passenger's seat, small panel that pops off. Reset S1 and re-programed the Master code and added the access codes.