The friendliest place on the web for anyone with an RV or an interest in RVing!
If you have answers, please help by responding to the unanswered posts.
Can I replace just these gears? I seem to have some worn and it won?t turn the lead screw for jacks. Motor works fine though. It?s $300 for new setup, I?d rather just buy the bad gear.
Thanks for the reply. It?s a 2013 Springdale 294. The gears are on the front stabilizer jacks. Has one screw that lowers two legs, one on each side. My rear one had a shear pin break. I gotta replace that. That?ll be easy. For now I?m just looking for the gears inside. Thanks again.
I'd check Grainger. But if you can't find these gears commercially available, maybe a local machine shop can fabricate a set for less than the cost of a new motor assembly?
A retired machinist recently made a custom input shaft for my landing gear.
Thanks guys. Yes, I?ll get the grease off and get a better picture. I?m not sure which gear is actually worn either. I got tied up the last few days. I will get a better picture.