Heli_av8tor
Senior Member
My controller is set for Absorb = 14.7v and Float at 13.5v. (Switches 4-5-6 = on-off-on). The remote verifies this setting.
However, the controller routinely runs in Absorb mode in the morning running the battery voltage to 15.0 to 15.1 before switching to Float mode.
This voltage is reported both by the Morningstar remote and my Trimetric battery monitor. This is with minimal overnight battery draw and/or on shore power (Xantrex Freedom XC 2000).
Batteries: 2 - FullRiver DC260-12
Why would it be doing this and how do I correct it?
Thanks,
Tom
However, the controller routinely runs in Absorb mode in the morning running the battery voltage to 15.0 to 15.1 before switching to Float mode.
This voltage is reported both by the Morningstar remote and my Trimetric battery monitor. This is with minimal overnight battery draw and/or on shore power (Xantrex Freedom XC 2000).
Batteries: 2 - FullRiver DC260-12
Why would it be doing this and how do I correct it?
Thanks,
Tom