You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
Recent content by donandlin
The friendliest place on the web for anyone with an RV or an interest in RVing!
If you have answers, please help by responding to the unanswered posts.
What can I use to clean old caulk off around skylight after scraping off the majority of it? Then I’ll reapply Dicor self leveling lap seal. Roof is fiberglass.
Now I really need help. I cut the white hose off to make it easier to access the clamp and then tried cutting that off with a Dremel but it doesn’t even make a scratch on the clamp. So now we have no water and I need suggestions please!
Is this a PEX cinch clamp? Can I replace it with the old fashioned one that tightens with a screwdriver? How do you remove the original one located in a very tight place? Thanks!
We can release the brass lever and drop the door down slightly but not enough to remove the door. I am going to unscrew as much of the track as possible and see if can be wedged out to exchange the new roller. Can’t find any cutouts.
John, the thing at the top of the closet that slides in the track looks like this:
I am referring to the white rollers on top. It’s the roller mechanism that needs replacing. The door does not have enough clearance to remove it. Then it appears I would have to unscrew the track and remove to...
First of all thanks Kirk for the picture of that cool tool. We’ll be ordering one. However after detaching the top and bottom part of the hardware the door still won’t come out with all the trim etc. And if we could get it out I can’t see how you could ever replace the top part in the track if...
This is a heavy bedroom closet door that runs the width of the motorhome. The screws loosened that hold the bracket to the door. There is no room to get in there with a screwdriver and I can’t figure out how to remove the door. The bottom part on the door can be loosened from the top part with...
Nasty job but we had the same problem and removed the hose connection and cleaned out all the plugged up little holes and all is well now. Just flush tank before it gets too full to avoid the problem.
Eureka yellow jacket central vac won’t turn off unless I flip the breaker off. Yesterday it worked fine. Checked bag and filter and all looks good. Also cleaned out floor kick plate but it is very difficult to pull it out to check wiring. What to do? Model CV-140, 9 years old. Thanks.
I need to find the EGR valve on our Maxxforce 10 (2012) engine. I need something more specific than what I find online. Pictures would be extremely helpful. Thanks!