Recent content by Flyingpiper59

Hey Forum Chums Got an 85 Pace Arrow last fall ....wintered in it with some fine advice From some folks on the forum..while building a permanent house on my land....put hay bales around the perimeter....but in extreme cold...my dump valves froze on a couple of occasions....I want to make it...

2 0f 2

It is a propane unit with electronic ignition....1985 Pace Arrow...Hopefully 2 pics coming of some old placards!

Greetings Forum Chums Just returned from a few days on the road to a dead water heater...turn on the switch...nothing...any ideas as where to start....I am a novice at WH repair....thought I would start at what seams to be the Electrical module and get it tested...not even a sound from the unit...

its a 150 gal...no sweating...

just as an update, today the furnace worked flawlessly....the temp was 40 and not 5....it cycled on and off as it should.....that being said....the furnace was working in a constant on mode when it was 5 out....even with the steps I took to insulate underneath...I am sure the R value is meager...

Thanks all....ordered a limit switch....coming on Tues....will see what that and a good tune up does...will post back!

volts good....took off the thermostat....jumped the wires....Heat working....I will see if it quits after a bit....sometimes it ran for a considerable length of time before it began to blow cold air

No I am afraid....just keeps running

Greetings Forum Chums, Wintering in my 1985 Pace Arrow while my house is being built....put hay bales around the perimeter...it got down to 5 degrees the other night..stayed warm inside...nothing froze underneath ....last couple of days the furnace comes on as it should...heats normally...then...

Some excellent input gentlemen...thanks to all Cheers! Ed

Hello Forum Chums, Gotta question regarding trying to reside this winter in my Pace Arrow 1985 that I recently acquired....aside from looking forward to fixing up this old beauty, I am breaking ground on a retirement home in the mountains in PA....If I leave the heat on and and open the access...

Greetings Forum Chums! Still working on the shake down of my Pace Arrow....Are combo units ok? Any advice or recommendations as to brand? My unit currently has neither! Many thanks! Ed

Did some plunging and purging and all of a sudden it drained very very quickly... so I don't know where it was hung up ....but afterwards I filled both tanks a couple of times and purged them again ...so everything seems to be in good shape now and running very freely.. Thanks!

Thanks for the input guys.... plunged and prodded.. wherever it was it broke loose and drained quite quickly at that point... spray a little bit of contact cleaner on some of the rocker switches and it appears that all of my tank readings and so on are now accurate... the last project that have...