Recent content by kentL

To clarify, the sensor I had replaced was the transmission output speed sensor on the Ford 4R100 tranny. The sensor is mounted on the left rear of the transmission. Hope this helps and you get yours running. kl

I had the same happen to me earlier this summer. The problem is due to noise on the line from the speed sensor to the computer and they developed a new cable, however they no longer make the cable. The Ford dealer recommended replacing the sensor which I did and I haven't had the issue again. kl

I switched to a blue seas 9012 after going thru 3 trombettas two of which failed with an open coil and the other the contactor failed. I didn't open any of the trombettas to check them out so not sure if they were heat induced failures. The blue seas has been in for couple years now and it works...

Dean, in reading your posts it sounds as if there is no other possible way to remove the blower motor with out removing the water heater, is that correct? Do you think it would be possible to cut a larger opening in the side ducting/housing where the motor is? I really want to not pull the water...

Dean, thanks for posting your work on the heater fan.  I am having the same problems with my heater and was just starting to research it when I came across your thread. I'll be racing Art to see your pics. Good job. kl

The 20 amp side of the gen does indeed go thru the transfer switch, you can look at the wiring schematic and see it. If this wasn't done then shore and genny power would not be isolated.

Tejas, the EMS does not look at the generator leg that powers the second ac compressor. The only way to tell, for me at least, is to just listen for the compressor to kick in.  In most of the 30 amp winnies with basement air the single leg of shore power feeds thru the leg 1 of the transfer...

The Winegard traveler automatic dish will work with a dish duo receiver. The traveler picks up 110,119 & 129 sats simultaneously, the traveler is a stationary unit though.

with a fault code of 3 you need to push the generator start/stop switch to "off" and this should then give you the second level fault, at least that's how the marquis is.

Opens and displays properly for me. Its a standard pdf document.

The 2000 35U Adventurer/Suncruiser do not offer seatbelts for the dinnette and in fact are placarded against sitting in the dinnette while underway, why they did this I'm not sure as some other years do have belts at the dinnette. ??? kl

Make sure you use an OILLESS air compressor if you blow out your lines as you dont want oil in your water lines. kl

Gary, my thought was to get the benifit of the two in one package and it also is a couple nickles cheaper. I wonder why they don't have a 30 amp model? Thanks kl

Is there any reason that a Surgeguard 50A Plus Hardwire Automatic Transfer Switch could not be used on a 30 amp system??

Dirko, I have the same rig as you. I replaced all 7 of my tires with the G670s, I ordered load range G but CW put on Fs it took CW a week to get the Gs in and installed so I had a good chance to compare and the Gs ride much better and the rig doesn't waddle like it used to. The G's also provide...