Recent content by Master-Tech

The second regulator on that tank basically keeps from line having full pressure from tank and not letting Liquid Propane into line which is bad Ju-Ju...  As well the 2 stage basically same first keep liquid out an tank pressure normal , 2nd regulates vapor whjch what all your appliances run on

their should be 4 phillips screws that hold the whole center in place that contains your panel, more than likely its shot, the bad news is the replacement contains that pcb in a retro kit with a new lower power cotrol board, to get it youll have to have your Model # and Serial # , the last one i...

what kinda switch ? Toggle, flat rocker ? Is it on the dash left of steering wheel or on wall in the coach, unless its been added by someone more than likely its a 12v power master shut off ,  maybe this help some, if had more info be helpfull, I"ve been working on Jayco RV"s since 1986 all...

i have tried several remanufactured cooling units from different companys, i say no names but price is 2/3rds of a new unit, my experience is you get what you pay for. I recommed new one from Manufactures, you get solid warranty and not refurbished / the cost and long life is your decision. ...

Take switch apart , more than likely spring has lost tension or corroded an switch may just be Bad. Was pump winterized? mostly when a pump freezes it gets end pump where the switch is most likely to break, even though pump will still run bypass switch and see, their a rotary pump an pretty...

I agree with Lou, i also belive your converter maybe trying to short out causing breaker to trip, a soft trip is just enough kick down but you gotta completely reset , if everything powering back-up after the reset , your strictly on battery reserve and furnance drops out at or around 9 1/2 to...

Be aware older tanks do have different eco and thermostates one set for AC and one set for LP Gas and they are respectfully totally different, later models only have one set on front tank , this uses the pcb. to regulate both power supplys, but rember the switchs aredifferent! make sure the set...

your correct fast flash means bad bulb on that side somewhere or broken wire leading too the bulb, you will get a dim flash on the towd if you have grounding problems with a significant amp draw,,  have you checked all lights , Front, Mirror, Most coachs have a Side Clearance lite that acts as...

There are several Manufactures of Gooseneck Adapters ,  They work very well as long as their installed properly , they lock on to the existing pin as well bolting through the mid plate. I have installed severall off these types for people who dont want a 5thwheel hitch but already have a...

Check your distribution panel under the hood out front, you may even have too remove the cover ,  inside youll find more fuses when remove complete cover youll find Relays you just may have a Bad One,  Oh by the way there are 2 Flashers one for Turn , one for Emergency .  Hope this small bit...

I agree with Gary , Full flow will mix the tank which flushes out sediments. Flush tank an lines well use ur drain on outside ita help. The are too keep hot on hot and to eleminate hot on cold side an vise verca, also alot manufactures use them in By-Pass Kit for Single lever Winterizeing, alwas...

Just for Mind eas Check your Thermistor - Not Thermocouple- unplug it take off fins  get ur Good true RMS Multimeter  anda glass Ice-Water,  Ohm thermistor and see what Reads then drop in icewater and getyour ohm reading ,  reome it an should go back ,,,,,, an Magic Numbers are  from 32 to 42...

A word of advice that switch was preset at or about 40 to 45lbs pressure , wich is all you need for the supply. If the pump is cycleing,  you may not have any water leaks on pressure side of the pump it would show itself, it very well may be on the Tank or Suck side of the pump wich less likely...

I would run the Tires at pressure rate on the tire ,  the 80lbs recommeded is for that certain load range,  lower tha pressure less tire can carry an could or will cause unwanted wear and damage,  most Manufactures are Super Close on the weight rates so be very carefull Please !    Rodney

Try boyh ways !  No matter your gona have some noise through floor orwhat ever ,,,    It being a Rotary Pump they gona have little Noise an Vibration  !!!!!      Rodney